高等学校化学学报 ›› 2013, Vol. 34 ›› Issue (4): 980.doi: 10.7503/cjcu20120572

• 物理化学 • 上一篇    下一篇

I-的光电化学氧化与光助充电二次锂离子电池

吴锋1,2, 谢潇怡1,2, 张存中1,2, 穆道斌1,2, 吴伯荣1,2   

  1. 1. 北京理工大学化工与环境学院;
    2. 国家高技术绿色材料发展中心, 北京 100081
  • 收稿日期:2012-06-14 出版日期:2013-04-10 发布日期:2013-03-20
  • 通讯作者: 张存中,男,博士,副教授,主要从事电化学和化学电源研究.E-mail:czzhangchem@bit.edu.cn E-mail:czzhangchem@bit.edu.cn
  • 基金资助:

    厦门大学固体表面物理化学国家重点实验室开放基金(批准号:2010-18)、动力电池及化学能源材料北京市高等学校工程研究中心开放基金(批准号:2012)和国家"九七三"计划项目(批准号:2009CB220100)资助.

Photo-electrooxidiation of I- and Photo-assistant Rechargeable Secondary Li-ion Battery

WU Feng1,2, XIE Xiao-Yi1,2, ZHANG Cun-Zhong1,2, MU Dao-Bin1,2, WU Bo-Rong1,2   

  1. 1. School of Chemical Engineering & Environment;
    2. National Development Center of Hi-Tech Green Materials, Beijing Institute of Technology, Beijing 100081, China
  • Received:2012-06-14 Online:2013-04-10 Published:2013-03-20

摘要:

采用扫描电子显微镜、 X射线衍射和粉末微电极分别考察了TiO2粉末的形貌、 结构以及氧化I-的光电化学行为. 结果表明, TiO2粉末晶型为锐钛矿, 粒径在100~200 nm范围内. 在光照条件下, 在TiO2半导体电极上电化学氧化I- 生成I2的超电势数值降低约1 V. 以TiO2/ITO和Li4Ti5O12分别作为正负极, 电解液为碳酸丙烯酯(PC)+LiClO4+LiI, 并以聚偏氟乙烯(PVDF)作为隔膜构成分隔式电解池, 进行整体电解并结合紫外-可见光谱进行分析. 结果表明, 该装置在光照条件下电池充电电压比非光照条件下的充电电压降低约0.9 V, 且充电效率接近100%. 该光电化学装置是一种可以利用光能充电的二次锂离子电池.

关键词: 光电氧化, 粉末微电极, 分隔槽, 锂离子电池, 钛酸锂

Abstract:

The structure, micro-morphology, particle size and photo-electrochemical behavior of TiO2 powder in I- contained PC electrolyte were investigated by XRD, SEM and micro-cavity electrode. The results indicate that the size of used TiO2 sample is from 100 nm to 200 nm. The results indicate that the potential of oxidation of I- on anatase-TiO2 is 1 V at irradiation condition, lower than that of oxidation of I- at dark condition. Furthermore, a type of photo-assistant rechargeable Li-ion battery was composed by anatase-TiO2/ITO semi-conductor photo-anode, poly(vinylidene fluoride)(PVDF) membrane and Li4Ti5O12 negative electrode. The charging voltage of such battery is 0.9 V at irradiation condition lower than that of the battery at dark condition. The results of UV-Vis spectroscopy indicate that the charging product of anode half-cell is I2. At the same time, the Li-ion insertion reaction happens on Li4Ti5O12 negative electrode. The total photo-assistant charging reaction of battery is listed as follows: 3LiI+Li4Ti5O12+3(3/2)I2+Li7Ti5O12. The results suggest that such batteries can be used as model for the development of next generation photo-assistant rechargeable Li-ion battery.

Key words: Photo-electrooxidization, Micro-cavity electrode, Divided cell, Li-ion battery, Li4Ti5O12

中图分类号: 

TrendMD: