酸性离子交换树脂催化酯化改质生物油的研究

高等学校化学学报 ›› 2009, Vol. 30 ›› Issue (9): 1754.

酸性离子交换树脂催化酯化改质生物油的研究

熊万明, 傅尧, 来大明, 郭庆祥

安徽省生物质洁净能源重点实验室, 中国科学技术大学化学系, 合肥 230026

收稿日期:2009-01-12 出版日期:2009-09-10 发布日期:2009-09-10
通讯作者: 傅尧, 男, 博士, 副教授, 主要从事有机化学与可再生能源研究. E-mail: fuyao@ustc.edu.cn; 郭庆祥, 男, 教授, 博士生导师, 主要从事绿色化学与可再生能源研究. E-mail: qxguo@ustc.edu.cn
基金资助:
国家“九七三”计划项目(批准号: 2007CB210205)和安徽省优秀青年科技基金(批准号: 08040106829)资助.

Upgrading of Bio-oil via Esterification Catalysted with Acidic Ion-exchange Resin

XIONG Wan-Ming, FU Yao*, LAI Da-Ming, GUO Qing-Xiang*

Key Laboratory of Biomass Clean Energy of Anhui Province, University of Science and Technology of China, Hefei 230026, China

Received:2009-01-12 Online:2009-09-10 Published:2009-09-10
Contact: FU Yao. E-mail: fuyao@ustc.edu.cn; GUO Qing-Xiang. E-mail: qxguo@ustc.edu.cn
Supported by:
国家“九七三”计划项目(批准号: 2007CB210205)和安徽省优秀青年科技基金(批准号: 08040106829)资助.

摘要/Abstract

摘要：

以磺酸型离子交换树脂为催化剂, 在模型反应的基础上, 探讨了该催化剂在稻壳裂解油及其轻质馏分的催化酯化改质过程中的活性和效果, 并通过气-质联用仪对酯化前后的生物油进行了成分分析. 结果表明, 酯化过程中采用的催化剂可以方便地分离和循环使用; 生物油中的有机酸顺利地转化为相应的酯类(主要为乙酸乙酯). 通过催化酯化改质后, 两种生物油的理化特性均得到了有效改善, 热值分别由16.80和12.76 MJ/kg提高到20.08和18.33 MJ/kg, 相应提高了19.5%和43.6%; 黏度分别由11.83和1.42 mm²/s, 下降到3.77和1.12 mm²/s; 水分分别为23.7%和28.4%, 流动性明显增强, 理化特性得到了明显提高. 为生物油的精制加工提供了一种有效方法.

关键词: 生物油; 固体酸; 离子交换树脂; 酯化

Abstract:

The corrosiveness of bio-oils is derived from organic acids, and it has limited the applications of bio-oil for current vehicles. But these acids can react with alcohol and convert into esters under mild condition with proper catalysts. The super-acid ion-exchange resin was applied to upgrade bio-oil and its light distillation fraction. The esterifiaction of bio-oils were preformed at 60 ℃ for 4 h, and the conversion of acetic acid approached 88%. Furthermore, the properties of bio-oils after esterification were improved significantly: the higher heating value approached 20.08 and 18.33 MJ/kg, which improved 19.5% and 43.6%, respectively. The viscosity was decreased from 11.8 and 1.42 mm²/s to 3.77 and 1.12 mm²/s, respectively; and the moisture is about 23.7% and 28.4%(mass fraction). The results of GC-MS show that organic acids in both bio-oils were successfully transformed into esters, primary ethyl acetate. Furthermore, the ion-exchanged resin could be convenient separated and reused, and would be a promising catalyst for upgrading of bio-oil.

Key words: Bio-oil; Solid acid; Ion-exchanged resin; Esterification

TrendMD:

熊万明, 傅尧, 来大明, 郭庆祥. 酸性离子交换树脂催化酯化改质生物油的研究. 高等学校化学学报, 2009, 30(9): 1754.

XIONG Wan-Ming, FU Yao*, LAI Da-Ming, GUO Qing-Xiang*. Upgrading of Bio-oil via Esterification Catalysted with Acidic Ion-exchange Resin. Chem. J. Chinese Universities, 2009, 30(9): 1754.

参考文献

[1]Chiaramontia D., Oasmaa A., Solantausta Y.. Renew. Sust. Energy Rev.[J], 2007, 11: 1056—1806
[2]Mohan D., Pittman C. U., Steele P. H.. Energy Fuels[J], 2006, 20: 848—889
[3]LU Qiang(陆强), ZHU Xi-Feng(朱锡锋), LI Quan-Xin(李全新), et al.. Progress in Chem.(化学进展)[J], 2007, 19: 1064—1071
[4]Ikura M., Stanciulescu M., Hogan E.. Biomass Bioenergy[J], 2003, 24: 221—232
[5]Senol O. I., Viljava T. R., Krause A. O. I.. Catal. Today[J], 2005, 100: 331—335
[6]Mahfud F. H., Ghijsen F., Heeres H. J.. J. M. Catal. A: Chem.[J], 2007, 264: 227—236
[7]Garcia L., French R., Czernik S., et al.. Appl. Catal. A: Gen.[J], 2000, 201: 225—239
[8]Bender M. H.. Resour. Conserv. Recy.[J], 2000, 30: 49—58
[9]Wang Z. X., Pan Y., Li Q. X., et al.. Appl. Catal. A[J], 2007, 320: 24—34
[10]Rioch C. E., Kulkarni S., Meunier F. C., et al.. Appl. Catal. B: Environ.[J], 2005, 61: 130—139
[11]Doshi V. A., Vuthaluru H. B., Bastow T.. Fuel Process Technol.[J], 2005, 86: 885—897
[12]Zhang Q., Chang J., Wang T. J., et al.. Energy Fuels[J], 2006, 20: 2717—2720
[13]Mahfud F. H., Cabrera I. M., Manurung R., et al.. Process Saf. Environ. Prot.[J], 2007, 85: 466—472
[14]Charles A. M., Akwasi A.. Energy Fuels[J], 2008, 22: 2104—2109
[15]QI Chao-Rong(戚朝荣), JIANG Huan-Feng(江焕峰), LIU Hai-Ling(刘海灵), et al.. Chem. J. Chinese Universities(高等学校化学学报)[J], 2007, 28(6): 1084—1087
[16]Peng J., Chen P., Lou H., et al.. Energy Fuels[J], 2008, 22: 3489—3492
[17]XU Ying(徐莹), CHANG Jie(常杰), ZHANG Qi(张琦), et al.. Petrochemical Technol.(石油化工)[J], 2006, 65: 594—618
[18]ZHI Hui-Zhen(职慧珍), LUO Jun(罗军), LÜ Chun-Xu(吕春绪), et al.. Chem. J. Chinese Universities(高等学校化学学报)[J], 2008, 29(4): 772—774
[19]ZHENG Ming-Dong(郑明东), CHEN Tong-Yun(陈同云), HU Ke-Liang(胡克良). Chem. J. Chinese Universities(高等学校化学学报)[J], 2006, 27(6): 1086—1090
[20]Delgado P., Sanz M. T., Beltran S.. Chem. Engin. J.[J], 2007, 126: 111—118
[21]YANG Jian-Ming(杨建明), KOU Lian-Gang(寇联岗), LÜ Jian(吕剑). Acta Chim. Sinca(化学学报)[J], 2005, 63: 396—400
[22]Izci A., Bodur F.. React. Funct. Polym.[J], 2007, 67: 1458—1464
[23]Nanla Ö., Oktar N., Tapan A. N.. Fuel[J], 2008, 87: 1789—1798
[24]Guo J. J., Jin T. S., Zhang S. L., et al.. Green Chem.[J], 2001, 3: 193—195
[25]Ardizzone S., Bianchi C. L.. Appl. Surf. Sci.[J], 1999, 152: 63—69
[26]Khder S. A., Hakam S. A., Sharkawy E. A., et al.. Catal. Commun.[J], 2008, 9: 769—777