喷砂-阳极氧化-氟化处理构筑铝合金超疏水表面

高等学校化学学报 ›› 2010, Vol. 31 ›› Issue (3): 456.

喷砂-阳极氧化-氟化处理构筑铝合金超疏水表面

周荃卉¹, 余新泉¹, 张友法¹, 李康宁¹, 陈锋¹, 顾忠泽²

1. 东南大学材料科学与工程学院, 江苏省先进金属材料高技术研究重点实验室, 南京 211189;
2. 东南大学生物科学与医学工程学院, 生物电子学国家重点实验室, 南京 210096

收稿日期:2009-04-10 出版日期:2010-03-10 发布日期:2010-03-10
通讯作者: 张友法, 男, 讲师, 主要从事金属基超疏水材料研究. E-mail: yfzhang@seu.edu.cn
基金资助:
国家自然科学基金(批准号: 50533030, 90401018, 60121101)资助.

Fabrication of Superhydrophobic Surface on Aluminum Alloy by Sandblasting-anodizing-fluorination

ZHOU Quan-Hui¹, YU Xin-Quan¹, ZHANG You-Fa^1*, LI Kang-Ning¹, CHEN Feng¹, GU Zhong-Ze²

1. Jiangsu Key Laboratory of Advanced Metallic Materials, School of Materials Science and Engineering, Southeast University, Nanjing 211189, China;
2. State Key Laboratory of Bioelectronics, School of Biological Science and Medical Engineering, Southeast University, Nanjing 210096, China

Received:2009-04-10 Online:2010-03-10 Published:2010-03-10
Contact: ZHANG You-Fa. E-mail: yfzhang@seu.edu.cn
Supported by:
国家自然科学基金(批准号: 50533030, 90401018, 60121101)资助.

摘要/Abstract

摘要：

为研究复合法制备超疏水表面过程中主要工艺参数对表面形貌及超疏水性能的影响, 开发了一种喷砂-阳极氧化复合方法, 在铝合金表面构筑了微米-纳米二级结构, 经氟化处理后获得了超疏水特性. 结果表明, 喷砂处理在铝合金表面通过冲蚀的凹坑构筑出微米结构, 阳极氧化则在铝合金表面通过蜂窝状氧化膜构筑纳米结构. 但单纯构筑粗糙结构或单纯改变表面化学组成均不能在铝合金表面获得超疏水特性. 单纯的微米结构或纳米结构, 即使有低表面能聚合物修饰也不能获得超疏水特性. 只有微米-纳米二级结构和低表面能聚合物的协同作用, 才能有效构筑铝合金超疏水表面. 这种铝合金与水滴接触时, 形成的气阱可减小固体表面与水滴的接触面积, 降低表面与水滴间的热量交换, 从而减缓水分子的凝结, 提高铝合金的抗霜冻性. 同时, 气阱还可有效减缓海水的腐蚀, 提高铝合金的耐海水腐蚀性.

关键词: 喷砂; 阳极氧化; 氟化; 超疏水

Abstract:

In order to study the influence of main processing parameters of composite method on the surface morphology and superhydrophobicity, sandblasting and anodizing were combined to obtain micro-nano structure on the surface of aluminum alloy. After the treatment of fluorination, the surface showed excellent superhydrophobicity. The results demonstrate that the structure at micron level is fabricated by sandblasting while the structure at nanometer level is prepared by anodizing. However, superhydrophobic surface cannot be achieved just by a rough surface structure or the decoration of polymer with low surface energy, or the combination of the decoration and single microstructure or nanostructre. The combination of the decoration and micro-nano structure is the key to attain superhydrophobicity on aluminum alloy. Gas-trap is intercepted during the contact of the surface with water droplets, which effectively reduces contact area and heat exchange between the surface and water droplets. Condensation of water molecules and corrosion of sea water are therefore slow down, which explains the improvement of frost resistance and corrosion resistance to sea water of the superhydrophobic surface on aluminum alloy.

Key words: Sandblasting; Anodizing; Fluorination; Superhydrophobicity

TrendMD:

周荃卉, 余新泉, 张友法, 李康宁, 陈锋, 顾忠泽. 喷砂-阳极氧化-氟化处理构筑铝合金超疏水表面. 高等学校化学学报, 2010, 31(3): 456.

ZHOU Quan-Hui, YU Xin-Quan, ZHANG You-Fa*, LI Kang-Ning, CHEN Feng1, GU Zhong-Ze. Fabrication of Superhydrophobic Surface on Aluminum Alloy by Sandblasting-anodizing-fluorination. Chem. J. Chinese Universities, 2010, 31(3): 456.

参考文献

[1]Sun T. L., Feng L., Gao X. F., et al.. Acc. Chem. Res.[J], 2005, 8(38): 644—652
[2]Gu Z. Z., Uetsuka H., Takahashi K., et al.. Angew. Chem. Int. Ed.[J], 2003, 42: 894—897
[3]Sato O., Kubo S., Gu Z. Z.. Acc. Chem. Res.[J], 2009, 42: 1—10
[4]Jin M. H., Feng X. J., Jiang L., et al.. Adv. Mater.[J], 2005, 17(16): 1977—1981
[5]Love J. C., Gates B. D., Wolfe D. B., et al.. Nano Letters[J], 2002, 2(8): 891—894
[6]Shirtcliffe N., McHale G., Newton M., et al.. Adv. Mater.[J], 2004, 16: 1929—1932
[7]Larmour I., Bell S., Saunders G.. Angew. Chem. Int. Ed.[J], 2007, 46: 1710—1712
[8]Han J., Jang Y., Lee D., et al.. J. Mater. Chem.[J], 2005, 15: 3089—3092
[9]Xi J., Wang S., Feng L., et al.. Appl. Phys. Lett.[J], 2008, 92: 053102-1—3
[10]Shirtcliffe N. J., McHale G., Newton M. I., et al.. Langmuir[J], 2005, 21(3): 937—943
[11]Qian B., Shen Z.. Langmuir[J], 2005, 21(20): 9007—9009
[12]QIAN Bo-Tai(钱柏太), SHEN Zi-Qiu(沈自求). Journal of Inorganic Materials(无机材料学报)[J], 2006, 21(3): 747—752
[13]Qu M., Zhao G., Cao X., et al.. Langmuir[J], 2008, 24: 4185—4189
[14]Qu M., Zhang B., Song S., et al.. Adv. Func. Mater.[J], 2007, 17: 593—596
[15]Zhang Y., Yu X., Zhou Q., et al.. Appl. Surf. Sci.[J], 2010, 256: 1883—1887
[16]Thieme M., Frenzel R., Schmidt S., et al.. Adv. Eng. Mater.[J], 2001, 3(9): 691—695
[17]Ren S., Yang S., Zhao Y., et al.. Surf. Sci.[J], 2003, 546: 64—74
[18]Luo Z., Zhang Z., Hu L., et al.. Adv. Mater.[J], 2008, 20: 970—974
[19]Wang S., Feng L., Jiang L.. Adv. Mater.[J], 2006, 18: 767—770
[20]WANG Jing-Ming(王景明), ZHENG Yong-Mei(郑咏梅), JIANG Lei(江雷). Chem. J. Chinese Universities(高等学校化学学报)[J], 2008, 29(12): 2484—2488
[21]XIAO Yi(肖怡), TANG Ji-Jun(汤继俊), KONG Qing-Gang(孔庆刚), et al.. A Method of Improving Hydrophobicity of Metallic Materials, CN 200610038572[P], 2006—08—09
[22]LIU Sheng(刘圣), GENG Xing-Guo(耿兴国), ZHOU Xiao-Feng(周晓峰), et al.. China Surface Engineering(中国表面工程)[J], 2008, 21(3): 31—34
[23]Shi F., Wang Z., Zhang X.. Adv. Mater.[J], 2005, 17: 1005—1009
[24]Osman M. M.. Mater. Chem. Phys.[J], 2001, 71: 12—16
[25]LIU Tong(刘通), LIU Tao(刘涛), CHEN Shou-Gang(陈守刚), et al.. Chinese Journal of Inorganic Chemistry(无机化学学报)[J], 2008, 24(11): 1859—1863
[26]Cassie A., Baxter S.. Trans. Faraday Soc.[J], 1944, 40: 546—551
[27]WEI Bao-Ming(魏宝明). Theory and Application of Metal Corrosion[M], Beijing: Chemical Industry Press, 1984: 39—89
[28]Nishino T., Meguro M., Nakamae K., et al.. Langmuir[J], 1999, 15: 4321—4323